Submitted by webroot on Thu, 09/05/2013 - 11:49
First: Read everything there is on RepRap's
The rest of this post will be more specific to my particular RepRap (Prusa i2) with and Arduino Mega 2560 and RAMPS 1.4.
Configuration and Calibration Tweaking guide:
First you really need to know your hardware.
Calibration offsets and setting in Configuration.h of Sprinter
Submitted by webroot on Thu, 08/29/2013 - 14:32
Setting up and Calibrating a RepRap Prusa i2
These notes are specific to RAMPS 1.4 on with an Arduino Mega 2560. This article assumes you have a built a Rep-Rap, tested the motors, stoppers, and have manually extruded some filament.
Submitted by webroot on Wed, 08/28/2013 - 16:56
Setup and configure a RepRap i2, Software and Firmware setup with Arduino Mega 2560, RAMPS 1.4.
This is an initial setup on a Windows 7 laptop that has none of the required software.
Software I will need to get:
1. Arduino IDE - http://arduino.cc/en/Main/Software <- I got Arduino 1.0.5 (Windows Installer)
2. Sprinter Firmware: https://github.com/kliment/Sprinter Download the ZIP on the right.